LOGic now supports interface to the Pegasus computer radio. This permits simultaneous use of LOGic and the Pegasus control program. LOGic can read and control the Pegasus.
This interface uses an intermediate disk file to pass information between the two programs. This file is buffered, so there is no actual wear and tear on your disk drive as you use the program.
Make sure you are running LOGic version 5.2.54 or later. Download the latest Pegasus software from Ten-Tec. This software must support PC Logging software interface. Currently, this software is located at http://www.tentec.com/Pegdvlp.htm. Install the software and run it. Insure that the software is communicating with the rig.
Run LOGic. Go to tools/setup/misc ham setup. Select Radio Ifc. Select the "Pegasus with disk file interface" driver. Leave the Port selection blank, and baud rate 0. This interface does not use a serial port. Click OK.
You will be prompted for the inteface disk file name. Select PEGASUS.OUT. It will be located in the same folder as the Pegasus software. LOGic will remember the file location and will not ask for it again. (The file name is stored in Pegasus.INI, which is located in the LOGIC5 folder.)
Note that the Pegasus program does not permit setting or reading of split status. LOGic merely assumes that split mode is on if the TX and RX frequencies are different.
If you need help getting the frequency and mode to be logged automatically, click here.
© 05 Apr 2002 by PDA