LOGic Forum
»
LOGic Support
»
Error Messages
»
NIST Clock sync error message
Rank: Advanced Member
Groups: Registered, Beta Testers
Posts: 392
Location: Richmond, TX
Thanks: 35 times
Was thanked: 54 time(s) in 51 post(s)
|
I am getting an error when the program tries to sync to NIST, whether automatically or manually. Is there a setup that needs to be done? It used to work fine before. Not now. 73, Allen N5XZ
|
|
|
|
|
|
Note: We receive a commission from Amazon when you purchase via this link. It does not affect your cost. Thank you!
|
|
|
Rank: Administration
Groups: Administrators, Beta Testers Posts: 3,061  Location: Auburn, GA Thanks: 974 times
Was thanked: 485 time(s) in 400 post(s)
|
What is the error message? People who have IPV6 internet service only have run into problems. There is no setup.
Try going to whatismyip.com and see if you have an IPV6 address.
Tnx & 73,
Dennis WN4AZY
|
|
|
|
|
|
Rank: Advanced Member
Groups: Registered, Beta Testers
Posts: 392
Location: Richmond, TX
Thanks: 35 times
Was thanked: 54 time(s) in 51 post(s)
|
Hmmm. I tried to capture the error message, but this time it worked. So, as they say..."Never Mind!" 73, Allen N5XZ
|
|
|
|
|
|
Rank: Administration
Groups: Administrators, Beta Testers Posts: 3,061 Location: Auburn, GA Thanks: 974 times
Was thanked: 485 time(s) in 400 post(s)
|
Ok, it must have been a local reachability issue or a short-term outage or something.
Tnx & 73,
DH
|
|
|
|
|
|
LOGic Forum
»
LOGic Support
»
Error Messages
»
NIST Clock sync error message
Forum Jump
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.
