logo
Welcome Guest! To enable all features please Login or Register.

Notification

Icon
Error

Rotor interface 90 degrees off
N5XZ
#1 Posted : Wednesday, April 7, 2021 11:07:44 AM(UTC)
Rank: Advanced Member

Groups: Registered, Beta Testers
Posts: 392
Location: Richmond, TX

Thanks: 35 times
Was thanked: 54 time(s) in 51 post(s)
For some reason, my rotor interface is now 90 degrees off AND the STOP button does not work. For example, if I click on 0 degrees, it sends 90 degrees to the rotor. I checked the setup and don't see anyway to specify the offset.
73, Allen N5XZ
Sponsor
Note: We receive a commission from Amazon when you purchase via this link. It does not affect your cost. Thank you!
K8ZM
#2 Posted : Wednesday, April 7, 2021 12:13:59 PM(UTC)
bwilliams

Rank: Advanced Member

Groups: Registered
Posts: 503
Location: Mentor, OH

Thanks: 119 times
Was thanked: 179 time(s) in 160 post(s)
Hi Allen,

Hope you are well !

I think STOP in the rotor control may or may not work depending on rotor mfg and/or model unless yours worked before. Mine is a Hygain DCU-3 and STOP works as it should. Rotor OFFSETs are set in the Band Table so a quick check of that will show if for some reason an offset got entered. I'm sure you checked the usual stuff like drivers and the like, also disable/re-enable the rotor, also assume the rotor works as it should without LOGic. I believe there is still a free standalone rotor controller application called LP-Rotor that you could try if your running Windows, there might be others as well but at least that may help trying to figure out if the rotor controller itself is the culprit.

73 de Brad, N8GLS

PS: Also PSTRotatorAz is another standalone application one can try.
N5XZ
#3 Posted : Wednesday, April 7, 2021 3:07:06 PM(UTC)
Rank: Advanced Member

Groups: Registered, Beta Testers
Posts: 392
Location: Richmond, TX

Thanks: 35 times
Was thanked: 54 time(s) in 51 post(s)
I went and checked the band table. Most were 0 offset but I think 80 was 90. I zeroed it anyway and now all is ok. Even the STOP works again. Go figger.
73, Allen N5XZ
1 user thanked N5XZ for this useful post.
WN4AZY on 4/7/2021(UTC)
K8ZM
#4 Posted : Wednesday, April 7, 2021 3:20:19 PM(UTC)
bwilliams

Rank: Advanced Member

Groups: Registered
Posts: 503
Location: Mentor, OH

Thanks: 119 times
Was thanked: 179 time(s) in 160 post(s)
Nice !!

Well, I tend to cherish those types of troubleshooting moments these days (HI HI) !!

Glad all is working again,

73, Brad N8GLS
1 user thanked K8ZM for this useful post.
WN4AZY on 4/7/2021(UTC)
Users browsing this topic
Guest
Forum Jump  
You cannot post new topics in this forum.
You cannot reply to topics in this forum.
You cannot delete your posts in this forum.
You cannot edit your posts in this forum.
You cannot create polls in this forum.
You cannot vote in polls in this forum.

Powered by YAF 1.9.5.5 | YAF © 2003-2011, Yet Another Forum.NET
This page was generated in 0.016 seconds.